Drive shaft cut and installed
100 2410
|
Drive shaft cut and installed
100 2409
|
Wiring complete in loom and bolted down
100 2289
|
Ends to coil heat shrinked
100 2288
|
Ends to coil squeezed on
100 2287
|
Ends squeezed on
100 2286
|
Heat shrinked and taped
100 2285
|
Adding wire to the resistor wire (red/white stripe)
100 2284
|
|
|
|
|
Drilling hole to mount coil bracket
100 2279
|
Ground straps finished
100 2278
|
Ground straps finished
100 2277
|
SS bolt & ground strap installed going to battery
100 2275
|
Drilling pilot hole for SS self tapping bolt
100 2274
|
Ground straps bolted down
100 2273
|
Ground straps bolted down
100 2272
|
Boting ground straps down
100 2271
|
3/8" x 1 1/2" SS bolt installed, couldn't find a brass/copper one
100 2270
|
Drilling hole in fender for grounding stud
100 2269
|
Bolting all the grounds together on the Motor frame mount
100 2268
|
Grounding starter
100 2267
|
Grounding cables
100 2266
|
Windshield vents installed. Will not install dash pad.
100 2265
|
Installed windshield vents
100 2264
|
Coil connector heat shrinked
100 2263
|
Coil connector, heat shrinked
100 2262
|
T-case vent tube, will add filter later
100 2259
|
Front axle vent line, will add filter later
100 2258
|
Brake lines to master cylinder installed
100 2257
|
Vin plate & Charcole canister holder painted & POR-15
100 2256
|
Side angle of top
100 2255
|
Rear of top. Need to shoot it with the U-POL Raptor to match the bed
100 2254
|
Windshield and top installed
100 2253
|
Hard top installed. Need to shoot it with the U-POL Raptor
100 2252
|
Jr cleaning hard top
100 2251
|
Windshield installed
100 2250
|
Windshield touched up
100 2249
|
Jr taping off the windshield for touch up
100 2248
|
1
